Wolf PWC482418 Installation Guide download pdf (Page 15)

Pro Wall Chimney Hood Installation 15

wolfappliance.com/specs

In-Line and Remote Blowers

WIRING FOR IN-LINE OR REMOTE BLOWER

1) Remove the hood electrical box cover. Run Romex

wire from a 120 V AC, 15 amp circuit to the hood

installation location. Insert the Romex

wire into the

electrical box by running it through the wire clamp

previously installed. Tighten the wire clamp to secure

the wire. Refer to the illustration and chart on the

previous page for the location of wiring for your

specific hood.

2) Run Romex

wire from the in-line or remote blower to

the hood installation location. Insert the blower cable

into the electrical box by running it through the other

wire clamp previously installed. Tighten the wire clamp

to secure the cable.

3) Cut off the butt crimp connector from the end of

orange wire in hood. Strip orange wire about

/8" (10).

Using an appropriate wire connector (not included),

connect black wire from blower to orange wire in hood.

4) Using the wire connectors provided, connect black

wire to power supply black wire, all white wires

together and green or bare wires from power supply

and blower to green ground screw in the electrical box.

5) Place all wiring connections inside the electrical box

and reinstall the cover. Make sure all wires are secure

and that no wires are pinched between the cover and

electrical box.

Before making electrical connections, make sure the

electrical power is turned off at the service panel.

Do not run wiring through the ductwork.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

No comments

Wolf PWC482418 Installation Guide Page 15