Wolf PWC482418 Installation Guide download pdf (Page 12)

) Using the #8 x 2" (51) screws (provided with hood),

secure the hood to the wood mounting strip. Refer to

the illustration below.

3) Using two #8 x 2" (51) screws and washers (provided

with hood), secure the top back of the hood to wall

studs or blocking by the upper slots. Then use three

#8 x 2" (51) screws and washers in the lower slots to

complete the installation of the hood to the wall. Refer

to the illustration below.

4) Connect the 10" (254) round ductwork to the transition

using sheet metal screws and duct sealing tape.

5) If you are installing an internal blower, do not reinstall

the internal frame and filters until blower installation

is complete. Refer to internal blower information on

page 15 and follow installation instructions provided

with the blower.

6) Proceed with hood wiring connections.

Pro Wall Chimney Hood Installation 12

Hood Installation

IMPORTANT NOTE: If an optional duct cover is to be used

with the pro wall chimney hood, it must be installed before

installing the hood. Refer to duct cover installation on the

previous page.

IMPORTANT NOTE: If a backsplash is to be used, it

should be installed prior to mounting the wall chimney

hood. Refer to installation instructions provided with the

backsplash.

The filters and internal frame must be removed from the

hood prior to installation. Refer to hood preparation on

page 10.

1) Lift the hood into position, resting the top back cavity

of the hood on the wood mounting strip.

UPPER SLOT

LOWER SLOT

MOUNTING

SCREW

WOOD

MOUNTING

STRIP

BACK OF

HOOD

Hood installation.

Due to the weight of the hood, be sure to have

adequate assistance for installation.

Support the hood until it is completely secured to the

wood mounting strip.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Wolf PWC482418 Installation Guide Page 12

Comments to this Manuals

Related products and manuals for Barbecues & grills Wolf PWC482418