Wolf PW482210 Specifications download pdf (Page 19)

19

Dimensions in parentheses are in

millimeters unless otherwise specified.

INSTALLATION INSTRUCTIONS

Do not remove the control knob bezel to

access hood wiring; this will damage the

bezel assembly.

Location of electrical box

IMPORTANT

NOTE

You must follow

all National

Electrical Code

regulations. In

addition, be aware

of local codes and

ordinances when

installing your

service.

ELECTRICAL WIRING

This ventilation hood must be properly

grounded. This unit should be installed by

a qualified electrician in accordance with

all applicable national and local electrical

codes.

Before servicing or cleaning unit, switch

power off at service panel and lock the

service disconnecting means to prevent

power from being switched on acciden-

tally. When the service disconnecting

means cannot be locked, securely fasten a

prominent warning device, such as a tag,

to the service panel.

Follow these instructions to install wiring for

all Wolf Pro wall hoods:

Run a 120 V AC, 15 amp circuit power cable

from the service panel to the electrical box

on the back plate.

Run the conduit connector through the

holes in the back plate. Refer to the illustra-

tion below for the location of the electrical

box.

Insert the conduit through the hole on top

of the back plate to the electrical box.

Remove the electrical box cover from the

back plate. Connect black wire to power

supply black wire, white wire to power

supply white wire and green wire to green

wire or bare wire.

Place all wiring connections inside the

electrical box and reinstall on the back plate

in the upper right-hand corner. Make sure

that the wires are secure and that no wires

are pinched between the cover and box.

Electrical

Box

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Comments to this Manuals

No comments