Wolf PW482210 Specifications download pdf (Page 16)

16

WOLF PRO WALL VENTILATION HOODS

24" (610) AND 27" (686) WALL HOODS

STEP 3: HOOD PREPARATION

IMPORTANT NOTE:

If a duct cover is to be

used, follow instructions on page 18 before

installing the wall hood. If you are installing a

recirculating kit, refer to instructions included

with the kit before installing the wall hood.

IMPORTANT NOTE:

Wolf recommends

installing the internal blower to the back plate

prior to mounting the hood.

If you are installing WBLOWER-60INT,

WBLOWER-90INT or WBLOWER-120INT,

refer to the internal blower information on

page 21 and follow installation instructions

provided with the blower assembly.

The hood assembly is shipped with the

back plate/transition attached. The

transition is shipped upside down in the top

of the hood. It must be removed and rein-

stalled in the proper position.

Remove the filters by pushing each filter up

at the angle it is placed in, and rotate down.

Remove the center filter first. Then take out

the grease cups placed on the bottom edge

of the hood coinciding with the bottom

edge of the filters. Gloves should be worn

to provide the proper grip when removing

filters.

Detach the back plate/transition assembly

from the hood by removing the screws

from the top and back of the assembly.

Refer to the illustration below.

Separate the transition from the back plate

by removing the shipping nut from the

inside of the back plate.

Position the back plate in the desired

location and mark the mounting holes on

the wood support. Drill pilot holes for the

mounting hardware.

If you are installing an in-line or remote

blower, drill an additional

7

/8" (22) hole

through the wood framing for the conduit

in order to run power to the blower. Refer

to the illustration on page 19 for location of

the electrical box and to the in-line and

remote blower information on pages 22–23.

Also, follow installation instructions

provided with the blower assembly.

IMPORTANT NOTE:

Do not run wiring for the

remote blower through the ductwork.

Back plate/transition assembly

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Comments to this Manuals

No comments