Wolf IDF606CG Specifications download pdf (Page 31)

WOLF WARMING DRAWERS

PLANNING INFORMATION

The Wolf 762 mm warming drawer is shipped

without any decorative drawer front. You must

order a stainless steel drawer front (tubular

handle included) or the integrated front (no

handle) for a custom wood application.

Specifications on the following pages provide

overall dimensions, rough openings and installa-

tion options for Model ICBWWD30 with stainless

steel and integrated drawer fronts. Note that

there are significant differences to the installa-

tion requirements for the integrated drawer front.

An anti-tip block or platform must be installed to

prevent the unit from tipping forward when the

drawer is opened.

The base platform must be able to support

91 kg. This platform must be a minimum of

25 mm above the toe kick to allow for the

16 mm overlap of the warming drawer trim.

Model ICBWWD30 may be installed below a

Wolf built-in oven or an electric or gas cooktop,

provided the warming drawer is fully enclosed,

top and bottom. It may also be installed next to

or above another Model ICBWWD30. Dimensions

will vary according to the specific installation.

STAINLESS STEEL DRAWER FRONT

Wolf recommends using a 838 mm wide cabinet

for the warming drawer with stainless steel

drawer front. A minimum 762 mm wide by

610 mm deep cabinet is required.

INTEGRATED DRAWER FRONT

IMPORTANT NOTE: A minimum 838 mm wide

cabinet is required for the warming drawer with

integrated drawer front. A minimum 610 mm

deep cabinet is required for an overlay applica-

tion and 635 mm deep cabinet for a flush inset

application.

Model ICBWWD30 with integrated drawer front

can accommodate installations with a 762 mm

or 914 mm cooktop. It may also be installed in

combination with a 762 mm single or double

oven or a 914 mm single oven. Dimensions will

vary according to the specific installation.

Keep in mind that the width of the custom panel

for the warming drawer with integrated drawer

front will vary according to the specific installa-

tion. The opening width will remain 749 mm

whether installed in combination with a 762 mm

or 914 mm cooktop or oven.

The decorative wood drawer front panel must

be a minimum of 16 mm thick.

ELECTRICAL REQUIREMENTS

Model ICBWWD30 is CB approved and manufac-

tured for a 220-240 V AC, 50/60 Hz electrical

supply. The service should have its own 15 or

20 amp circuit breaker, and a grounded 3-prong

receptacle should be located within reach of the

power cord and flush with the back wall. Locate

electrical within the shaded area shown in the

installation illustrations on the following pages.

FRONT PANEL OPTIONS

Model ICBWWD30

Classic Stainless WWDFRONT/S

Integrated WWDFRONT/I

(accepts wood panel)

Optional drawer front panels are

ordered and shipped as sales

accessories. Stainless steel drawer

front panels include matching tubular

handle.

597 mm

BEHIND FRAME

759 mm

OVERALL WIDTH

229 mm

689 mm

OVERALL DEPTH

260 mm

OVERALL DIMENSIONS

Model ICBWWD30 with Stainless Steel Drawer Front

ACCESSORIES

Optional accessories

are available

through your Wolf

dealer.

746 mm

OVERALL WIDTH

597 mm

BEHIND FRAME

229 mm

257 mm

Model ICBWWD30 with Integrated Drawer Front

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 71 72

Comments to this Manuals

No comments

Wolf IDF606CG Specifications Page 31

Comments to this Manuals

Related products and manuals for Barbecues & grills Wolf IDF606CG