Wolf CART36 Installation Guide download pdf (Page 9)

Outdoor Grill Installation 9

wolfappliance.com

Electrical Requirements

INSTALL THE POWER TRANSFORMER

Wolf outdoor grills and the burner module have a power

transformer for the lights and igniters which is concealed

in a stainless steel box with an attached power supply

cord.

BUILT-IN APPLICATION: Secure the transformer box in a

dry location, away from the grill firebox and excessive heat

area, but within 2' (.6 m) of the right rear grill opening.

CART APPLICATION: Two mounting screws are provided

at the bottom right rear corner of the cart to secure the

transformer box. If a side burner is being attached to a

cart, it will utilize the same transformer as the gas grill.

IMPORTANT NOTE: Do not install the transformer box

inside the insulating liner. The transformer box must be

secured away from excessive heat and in a dry location.

Make the transformer connections to the wire harness

located at the right rear of the grill to the harness of the

transformer box.

Plug the power cord from the transformer into a properly

grounded GFCI 120 V AC outlet. The outlet must be

located within 6' (1.8 m) of the transformer.

ROTISSERIE MOTOR

The rotisserie motor requires a GFCI 120 V AC electrical

supply. The 9' (2.7 m) power cord on the motor is

equipped with a 3-prong grounded plug for protection

against shock hazard.

IMPORTANT NOTE: The burner module must be installed

at least 12" (305) from the rotisserie motor.

ELECTRICAL GROUNDING: The outdoor gas grill is

equipped with a 3-prong grounding plug for protection

against shock hazard. It should be plugged directly into

a properly grounded 3-prong outlet. Do not cut or

remove the grounding prong from the plug.

DO NOT use an extension cord or two-prong adapter.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

No comments

Wolf CART36 Installation Guide Page 9