Wolf PW362210 Installation Guide download pdf (Page 21)

Pro Wall Hood Installation 21

wolfappliance.com/specs

In-Line and Remote Blowers

BLOWER INSTALLATION

IMPORTANT NOTE:

Refer to specific installation instruc-

tions provided with each blower assembly for additional

mounting and wiring instructions.

IMPORTANT NOTE: Use wire connectors or wire nuts

approved by UL or C/UL.

• Follow specific wiring instructions provided with each

blower. Black (L1) to black, white (neutral) to white, or

white to blue, or white to brown (depending on model)

and green to grounding screw. Run ROMEX cable to

the hood.

• Insert 6" (152) of ROMEX cable through the knockout

opening and into the electrical box on the back plate of

the hood. Secure the cable to the electrical box with an

appropriate connector.

• Locate the cord assembly provided with the blower.

The cord assembly has two leads, black (L1) and white

(neutral). Connect these leads to the leads from the

blower, black to black and white to white.

• Connect all green and bare wires together to the

ground screw in the electrical box.

•

Plug the cord assembly into the receptacle located

near the center of the hood shell. Refer to the illustra-

tion below. Use the clips on the interior of the hood to

secure excess power cord.

• Reinstall the electrical box cover and screws in the

upper right-hand corner of the hood. Make sure all

wires are secure and that no wires are pinched

between the cover and box.

IMPORTANT NOTE: Before turning the power on to the

ventilation hood, make sure the blower is off.

When making electrical connections, make sure the

electrical power is turned off at the power source or

circuit breaker before proceeding.

BLOWER

RECEPTACLE(S)

Location of receptacle(s).

1 2 ... 16 17 18 19 20 21 22 23 24

No comments

Wolf PW362210 Installation Guide Page 21