Wolf PW362210 Installation Guide download pdf (Page 16)

Pro Wall Hood Installation 16

24" and 27" Deep Wall Hoods

REATTACH BACK PLATE

Attach the transition to the back plate using the four

shipping screws provided in the hardware mounting kit.

Reinstall the shipping screws removed previously from the

top and back of the back plate. Seal with duct tape to

ensure a tight seal from the transition to the back plate.

If additional support is required, drill supplementary

mounting holes in the back plate and use these holes to

attach the hood assembly to the wall framing.

HOOD INSTALLATION

IMPORTANT NOTE:

If a backsplash is to be used, it should

be installed prior to mounting the wall hood. Refer to

installation instructions provided with the backsplash.

Align the mounting holes in the back plate of the hood

assembly with the retaining brackets on the wood

mounting support. Refer to the illustration below for

location of the mounting holes, one on each side of the

back plate.

Position the hood and install the #10 x 1

/2" (38) screws

and washers provided through the mounting holes on the

back plate. Verify that the screws engage the mounting

support. Attach the transition to existing ductwork with

sheet metal screws and seal with duct tape. Refer to the

illustration below.

/16

(113)

(64)

MOUNTING

HOLE

Location of mounting holes. Hood installation.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Wolf PW362210 Installation Guide Page 16