Wolf CT30EU Installation Guide download pdf (Page 14)

Verify Cooktop Operation

efore operating the electric cooktop, be sure to read the

entire use & care guide included with the cooktop for

important safety, operating and warranty information.

Clean the glass-ceramic surface as recommended in the

electric cooktops use & care guide. The cooktop surface

must be free of any foreign substances, especially those

that could melt and permanently adhere to the glass-

ceramic.

Turn on the electrical supply to the cooktop. Check opera-

tion of the controls and verify that each of the heating

elements is coming up to temperature.

IMPORTANT NOTE: A small amount of smoke and odor

may be noticed during the initial break-in period.

Electric Cooktop Installation 14

Install the Cooktop

ttach the foam strip to the underside of the cooktop

frame. Refer to the illustration below. For unframed

cooktops, be sure to adhere the foam strip to the outer

edge of the glass-ceramic top, not the support frame.

Gently lower the unit into the cut-out area in the counter-

top and center. Check that the front edge of cooktop is

parallel to the front edge of the countertop. Check that all

required clearances are met.

Attach the brackets to the bottom of the cooktop, as

shown in the illustration below. Install clamping screws

into the brackets and tighten until the screws contact the

underside of the countertop. Do not overtighten screws.

IMPORTANT NOTE: Do not seal the cooktop to the coun-

tertop. It must be removed if service is necessary.

FOAM

STRIP

COOKTOP FRAME

Foam strip. Installation brackets.

COUNTERTOP

BRACKET

SCREWS

BRACKET

4" (102)

CLAMPING

SCREW

Do not operate the cooktop if the glass-ceramic surface

is broken. Call a Wolf authorized service center.

Cooktop Removal

IMPORTANT NOTE: Cooktop removal should only be done

by a Wolf authorized service center technician.

If it is necessary to remove the cooktop for cleaning or

service, disconnect the electrical supply. Remove the

mounting brackets and remove the cooktop. Reinstall in

the reverse order.

For flush mount installations, use a razor blade to carefully

cut around the perimeter seal. A new RTV installation kit

will be required to reinstall the cooktop. This kit and other

accessories are available through your authorized Wolf

dealer. To obtain local dealer information, visit the find a

showroom section of our website, wolfappliance.com.

1 2 ... 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Wolf CT30EU Installation Guide Page 14

Comments to this Manuals

Related products and manuals for Barbecues & grills Wolf CT30EU